Once disassembled, you will see:

If your Honor 9C is stuck in a boot loop, won't turn on, or has a corrupted partition, standard recovery methods might fail. That’s where the comes in. By using a hardware "test point," you can force the device to be recognized by your PC as Qualcomm HS-USB QDLoader 9008 , allowing you to flash firmware even when the phone seems dead. What You’ll Need The Phone : Honor 9C (disassembled). A Tweezers or Conductive Wire : To short the test points. USB Cable : High-quality data cable. Drivers : Qualcomm USB Drivers installed on your PC. Flashing Tool : Tools like Miracle Box, UnlockTool, or QFIL . Locating the Go to product viewer dialog for this item. EDL Test Point

The EDL point is a physical test point located on the device’s motherboard. It consists of two exposed copper pads or pins. By shorting these two points (creating an electrical connection between them) using a metal object like tweezers while the battery is connected, you force the device to boot directly into Emergency Download Mode.

: Allows for "deep flashing" of the stock ROM when the bootloader is locked.

The test points are located on the motherboard, typically near the battery connector or under a metal shielding plate. Procedure: You must short these two specific gold pins

using a pair of metal tweezers while simultaneously connecting the phone to a PC via a USB cable. Steps to Enter EDL Mode (9008) Power Off: Ensure the device is completely powered down. Disassemble: