For drives without display, read the :
| Error Code | Name | Description | Solution | |------------|------|-------------|----------| | | Invalid parameter set | Loaded parameters from EEPROM are corrupted | Restore factory defaults via FCT (“Restore” command). Re-commission. | | W-5005 | Parameter out of range | User attempted to write invalid value to an index | Check parameter limits in the manual (e.g., P.08 max 2400 rpm). | | E-5010 | IO-Link communication timeout | Cyclic data exchange interrupted | Check IO-Link master and cable (max 20 m unshielded). Verify M12 pin assignment (X2). | | F-6000 | Internal firmware error | Non-recoverable software fault | Cycle 24 V power. If persistent, contact Festo support (likely hardware failure). | cmmo-st-c5-1-diop error codes
Key features that relate to error generation include: For drives without display, read the : |
Encoder cable not shielded, crosstalk from motor phases. | | E-5010 | IO-Link communication timeout |
