Xmk-010 Manual ^new^ Jun 2026

All rights reserved. No part of this manual may be reproduced without written permission.

| Code | Meaning | Likely Cause | Solution | | :--- | :--- | :--- | :--- | | | No input or over-range | Broken sensor, loose wire | Check continuity of sensor | | HHH | Input > upper limit | Short circuit (TC) or wrong INP | Verify input type setting | | LLL | Input < lower limit | Reverse polarity (TC) | Swap IN A and IN B wires | | Er1 | Parameter corruption | Electrical noise | Reset to factory defaults (see below) | | Er2 | Autotune failed | Too much disturbance | Run autotune again in stable conditions | xmk-010 manual

Note: Allow at least 50mm clearance behind the panel for wiring and ventilation. All rights reserved

Document version 2.0 – Compiled from standard industrial controller practices. Always follow local electrical codes. Document version 2

Ads

`);doc.close();} `); doc.close(); }